2jz Gte Coolant Flow Path Mkiv Technical The Mkiv Supra Owners Club Torque: engine drain plug. 29 n⋅m (300 kgf⋅cm, 22 ft⋅lbf) fill engine coolant. slowly fill the system with coolant. use a good brand of ethylene–glycol base coolant and mix it according to the manufacturer’s directions. using coolant which includes more than 50 % ethylene–glycol (but not more than 70 %) is recommended. Thought the cams weren't dialled in correctly so did that, and there was significant adjustment there. however the temps were still reaching 108 degrees at only 1.3 bar. bled the life out of the system again and again. new water pump new stat. the works. finally last night i managed to solve the problem and restore the coolant flow to the system.
2jz Engine Diagram In this video i go over how to simply the engine wiring and the coolant routing on the 2jz. it tidys up the engine bay and makes it a whole lot easier to wor. Regulating coolant flow to from heater core & coolant hose routing. some background first i have an altezza is300 with a 2jz gte aristo swap. the car doesn't have a heater core installed so the inlet outlet hoses shown below are both capped off at the tip with coolant hose cap hose clamps. according to the coolant flow diagram, this. 806 posts · joined 2001. #2 · dec 17, 2011 (edited) flows out of the back of the head to the heater core and then back to the pipe that's along the side of the block which goes to the water pump. coolant flows to the radiator from the motor through the top hose and back to the water pump t stat housing through the bottom hose. In early 1986, the third generation of the supra was introduced. it is also the first that has not been marketed with the suffix celica. the second generation was presented in the fall of 1981 and had a completely independent drive with the new (170 hp) 6 cylinder engines. the first supra built from spring 1978 to summer 1981 was still offered.
Comments are closed.